QNAP QTS 4.5 Series - Page 534

Creating a Custom Filter Tab for System Access Log on the Sender Device
1. Open QuLog Center.
2. Go to QuLog Service > Sender Devices
3. Click on a sender device.
4. Go to System Access Log .
5. Go to the search bar.
6.
Click .
7. Specify the following filter fields:
Fields Steps
Severity Level a.
Click .
The severity level drop-down menu appears.
b. Select a severity level option.
Accessed Resources a.
Click .
The content condition option appears.
b. Select a condition.
c. Specify the keywords.
Date a.
Click .
The date drop-down menu appears.
b. Select a date option.
Connnection type a.
Click .
The connection type option appears.
b. Select a connection type.
User a.
Click .
The user condition option appears.
b. Select a condition.
c. Specify the keywords.
Action a.
Click .
The action drop-down menu appears.
b. Select an action option.
Source IP a.
Click .
The source IP address condition option appears.
b. Select a condition.
c. Specify the source IP address.
QTS 4.5.x User Guide
QuLog Center 533