Command reference
R&S
®
ZNL/ZNLE
913User Manual 1178.5966.02 ─ 20
Parameters:
<ConnectorType> N50Female | N50Male | N75Female | N75Male | PC7 |
SMAFemale | SMAMale | PC35female | PC35male |
PC292female | PC292male | PC24female | PC24male |
PC185female | PC185male | S7_16female | S7_16male |
BNC50male | BNC50female | BNC75male | BNC75female |
UFEMale1 | UMALe1 | UFEMale2 | UMALe2 | WM864 |
WM1295 | WM1651 | WM2032 | WM2540 | WR02 | WR03 |
WR05 | WR06 | WR08 | WR10 | WR12 | WR15
Connector type and gender of the connectors (omitted for
query). The R&S ZVR-compatible parameters UFEMALE1 and
UMALE1 denote the user-defined connector type "UserConn1",
UFEMALE2 and UMALE2 denote the user-defined connector type
"UserConn2". The user-defined connector types must be defined
before being addressed by
[SENSe<Ch>:]CORRection:COLLect:
CONNection<PhyPt>.
*RST:
N50FEMALE for all ports.
Example:
*RST; :CORR:COLL:CONN1 N75MALE; CONN4?
Change the connector type at port 1 from N50FEMALE to
N75MALE. The connector type at the other ports is also
changed to N75, however, the gender (female) is maintained.
CORR:COLL:CONN4? returns N75FEMALE.
Manual operation: See "Connector" on page 402
[SENSe<Ch>:]CORRection:COLLect:CONNection:GENDers <Gender>
Qualifies whether the genders at the test ports (but not their connector types) are equal
or independent.
Suffix:
<Ch>
.
Channel number of the calibrated channel
Parameters:
<Gender> ALL | SINGle
ALL – equal (uniform) genders. If the gender at one port is
changed, the connector type at all other ports is changed
accordingly.
SINGle – independent (possibly non-uniform) genders at the
ports.
*RST: SINGle
Example: See [SENSe<Ch>:]CORRection:COLLect:CONNection:
PORTs
Manual operation: See "Same Connector All Ports / Same Gender All Ports"
on page 485
VNA command reference
To Next Page
Loading...
