R&S ZVB - Page 1027

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 1012
Set power control method (SOURce<Ch>:POWer<Pt>:CONVerter:TRANsfer:DESCription DSET;
DSET USER).
This is a global setting.
<Ch>
Channel number. This suffix is ignored, the command affects all channels.
<Pt>
Converter port number
'<directory>'
String parameter to specify an existing directory path
*RST value
n/a (a *RST does not affect the general frequency converter settings)
SCPI, Command
Types
Device-specific, command or query
Example:
SOUR:POW1:CONV:TRAN:DESC DSET
Enable the RF IN power (and Electronic Attenuator) with Data Set control
method for converter port 1.
CONV:TRAN:DSET USER
Use linearization data collected with the leveling tool
CONV:TRAN:PATH 'C:\Program Files\Rohde&Schwarz\Network Analyzer\FrequencyConverter'
SOURce<Ch>:POWer<Pt>:CONVerter:TRANsfer:SLOPe <slope>
Specifies the slope for the linear power transfer approximation (Slope value in Linear Approximation
dialog).
Since FW version 3.40 this is a global setting.
<Ch>
Channel number. This suffix is ignored, the command affects all channels.
<Pt>
Converter port number
<slope>
Slope in the linear power transfer model
Range [def. unit]
1 to 1000000 [1], the increment (UP | DOWN) is 1
*RST value
n/a (a *RST does not affect the general frequency converter settings)
SCPI, Command Types
Device-specific, command or query
Example:
See SOURce<Ch>:POWer<Pt>:CONVerter:TRANsfer:DESCription
SOURce<Ch>:POWer<Pt>:CORRection...
This subsystem controls the source power calibration.
Note: The SOURce<Ch>:POWer... subsystem comprises port-specific and general settings. Port-
specific settings are valid for the port specified by the numeric suffix <Pt> (...:POWER<Pt>:...). General
settings are valid for all test ports of the analyzer; the port suffix is ignored. Refer to the description of the
individual commands for more information.