R&S ZVB - Page 1063

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 1048
check whether an event has occurred since the last reading.
STATus:QUEStionable:INTegrity:HARDware:NTRansition
Sets the negative transition filter. If a bit is set, a 1 to 0 transition in the corresponding bit of the associated
condition register causes a 1 to be written in the associated bit of the corresponding event register.
<NRf>
0 to 65535 (decimal representation)
*RST value
– (see also Reset Values of the status reporting system)
SCPI, Command
Types
Confirmed, command or query
Example:
STAT:QUES:INT:HARD:NTR 394
Set bits no. 1, 3, 7, and 8 of the
QUEStionable:INTegrity:HARDware:NTRansition register
STATus:QUEStionable:INTegrity:HARDware:PTRansition
Sets the positive transition filter. If a bit is set, a 0 to 1 transition in the corresponding bit of the associated
condition register causes a 1 to be written in the associated bit of the corresponding event register.
<NRf>
0 to 65535 (decimal representation)
*RST value
– (see also Reset Values of the status reporting system)
SCPI, Command
Types
Confirmed, command or query
Example:
STAT:QUES:INT:HARD:PTR 394
Set bits no. 1, 3, 7, and 8 of the
QUEStionable:INTegrity:HARDware:PTRansition register
STATus:QUEStionable:INTegrity:NTRansition
Sets the negative transition filter. If a bit is set, a 1 to 0 transition in the corresponding bit of the associated
condition register causes a 1 to be written in the associated bit of the corresponding event register.
<NRf>
0 to 65535 (decimal representation)
*RST value
– (see also Reset Values of the status reporting system)
SCPI, Command Types
Confirmed, command or query
Example:
STAT:QUES:INT:NTR 4
Set bit no. 2 of the QUEStionable:INTegrity:NTRansition register