R&S ZVB - Page 1076

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 1061
*RST value
*RST has no effect on the calibration algorithm.
SCPI, Command Types
Device-specific, command or query
Example:
SYST:CORR:FMP ON
Enable fast multiport correction.
SYSTem:DATA:SIZE ALL | AUTO
Defines the block size for the data transfer between the instrument hardware and the software. The block
size has an impact on the display of traces and on the readout of trace data using the commands of the
TRACe... or CALCulate<Chn>:DATA... subsystems.
ALL
Data transfer with full buffer size. The data for each sweep are transferred together
so that each displayed trace contains the data of exactly one sweep. The same is
true for queried trace data. The trace is displayed or updated at once, the sweep
progress is not visible on the screen.
To make sure that all queried trace points stem from the same sweep you can
also use single sweep mode (INITiate<Ch>:CONTinuous OFF) and the common
command *OPC?
AUTO
Data transfer with an automatically determined block size. In general the data blocks
comprise only part of a trace, therefore the sweep progress is visible on the screen.
On the other hand the displayed trace can show the results of two consecutive
sweeps.
*RST value
AUTO.
SCPI,
Command
Types
Device-specific, command or query
Example:
SYST:DATA:SIZE ALL
Select data transfer with full buffer size in order to view the trace data from a single
sweep..
SYSTem:DATE <Year>, <Month>, <Day>
Queries or defines the instrument's current date setting. The setting command requires administrator
rights.
<Year>
<Month>
<Day>
Four-digit number
Two-digit number, 01 (for January) to 12 (for December)
Two-digit number, 01 to the number of days in the month
*RST value
n/a
SCPI, Command Types
Confirmed, command or query
Example:
SYSTem:DATE?
Response: 2012,05,01 – it is the 1st of May, 2012.