R&S ZVB - Page 1079

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 1064
SYSTem:ERRor:DISPlay <Boolean>
Switches the display of a tooltip for remote command errors on or off. The tooltip appears at the bottom of
the remote screen and of the manual screen; it is not displayed for SCPI errors no. –113, Undefined
header.
<Boolean>
ON | OFF – Switch the tooltip on or off.
*RST value
OFF
SCPI, Command Types
Device-specific, command or query
Example:
SYST:ERR:DISP ON
Switch the display of the tooltip for remote command errors on.
FREQ:STAR 1
SYSTem:FIRMware:UPDate '<file_name>'
Installs a firmware version stored in a NWA setup file (*.msi) on the analyzer. The installation is automatic
and does not require any further action.
'<file_name>'
String variable for the name and directory of a NWA setup file (*.msi).
*RST value
–
SCPI, Command
Types
Device-specific, no query
Example:
SYST:FIRM:UPD 'C:\Setup\ZVAB_01.10.msi'
Install the firmware version 01.10 from the setup file stored in the Setup
directory of the analyzer's internal hard disk.
SYSTem:FPReset
Similar to SYSTem:PRESet, but in addition deletes all channels from the active setup.
As a result, the active setup contains no channels, traces, and diagrams. Other open setups remain
unchanged.
*RST value
–
SCPI, Command Types
Device-specific, no query
Example:
SYST:FPR
Reset the parameters of the current setup and delete channel 1.
SYSTem:FREQuency? MINimum | MAXimum
Queries the minimum and maximum frequency of the network analyzer. For an overview refer to the