R&S ZVB - Page 433

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT GUI Reference
Channel Menu
Operating Manual 1145.1084.12 – 30 418
Path
The Path tab allows to set up the channel specific RF path configuration of the extension unit.
The picture below shows a R&S ZVAX-TRM equipped with all available options. Modules drawn in black
are looped into the signal path, while modules drawn in grey are bypassed.
Building Blocks
The following table presents the GUI representation of the available building blocks.
Graphical
Representation
Name
Remarks
Pulse modulator on source path
i=1,2,3 with a-wave (REF signal)
access
The a-wave access allows to use the
unpulsed CW signal as the REF signal. It can
only be used if the pulse modulator is looped
into the signal path.
Power amplifier
-/-
Combiner for source paths 1 and
3 (source paths 2 and 4), output
to port 1 (port 2) and with a-wave
access to path 2 (path 4)
The a-wave access allows to access the
combiner input from path 3 (path 4). It can be
used irrespective of whether the combiner is
looped into the signal path or not.