R&S ZVB - Page 575

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT GUI Reference
System Menu
Operating Manual 1145.1084.12 – 30 560
 LXI Status Enabled switches the LXI logo in the status bar on or off.
For instruments running Windows 7, LXI is currently not fully supported and hence this control is
disabled.
 LAN Config Initialize initiates the network configuration reset mechanism (LCI) for the instrument.
Default state of the network settings
According to the LXI standard, an LCI must place the following parameters to a default state.
Parameter
Value
TCP/IP Mode
DHCP + Auto IP Address
Dynamic DNS
Enabled
ICMP Ping
Enabled
Password for LAN configuration
LxiWebIfc
The LCI for the network analyzer also resets the following parameters:
Parameter
Value
Hostname
<Instrument-specific host name>
Description
Vector Network Analyzer
Negotiation
Auto Detect
VXI-11 Discovery
Enabled
The LAN settings are configured using the instrument's LXI Browser Interface.
The tables in the External Receiver panel show the R&S ZVA network analyzers which may be used as
remote receivers for a mixer delay measurement.