R&S ZVB - Page 638

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 623
MLINear
Calculate the magnitude of z, to be displayed in a Cartesian diagram with a linear scale
MLOGarithmic
Calculate the magnitude of z, displayed in a Cartesian diagram with a logarithmic scale
PHASe
Phase of z, displayed in a Cartesian diagram with a linear vertical axis
UPHase
Unwrapped phase of z, displayed in a Cartesian diagram with a linear vertical axis
POLar
Magnitude and phase, displayed in a polar diagram
SMITh
Magnitude and phase, displayed in a Smith chart
ISMith
Magnitude and phase, displayed in an inverted Smith chart
GDELay
Group delay, displayed in a Cartesian diagram
REAL
Real part (x), displayed in a Cartesian diagram
IMAGinary
Imaginary part (y), displayed in a Cartesian diagram
SWR
Standing Wave Ratio (SWR), displayed in a Cartesian diagram
COMPlex
x, y, displayed in a polar diagram
MAGNitude
Magnitude (sqrt(x
2
+ y
2
)), displayed in a Cartesian diagram with a logarithmic scale
CALCulate<Chn>:FORMat:WQUType POWer | VOLTage
Selects the physical unit of the displayed trace.
<Chn>
Channel number used to identify the active trace
Parameters
Power or voltage units
*RST value
POWer
SCPI, Command
Types
Confirmed, command or query
Example:
CALC4:PAR:SDEF 'Ch4Tr1', 'b1'
Create channel 4 and a trace named Ch4Tr1 to measure the wave quantity b
1
.
The trace becomes the active trace in channel 4.
CALC4:FORM:WQUT VOLT
Select voltage units for the created trace (identified by the suffix 4).
CALCulate<Chn>:FSIMulator...
This subsystem enables the virtual SAW Matching Network and defines its parameters. When the virtual
network is enabled, port 1 serves as an unbalanced port, the physical ports no. 2 and 4 of the analyzer are
combined to a logical (balanced) port no. 2.
The commands in this subsystem are supported for the sake of compatibility with older firmware
versions. Starting with firmware V1.70 the commands have been superseded by the
CALCulate:TRANsform:VNETwork... subsystem. Virtual network (de-)embedding is controlled by the
Virtual Transform menu.
The commands may be removed in future firmware versions.