R&S ZVB - Page 784

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 769
MMEMory:DELete '<file_name>'[, FORCe]
Removes a file from the specified directory.
'<file_name>'
String parameter containing the path and file name of the removed file. If the path
is omitted, the current directory is used (see MMEMory:CDIRectory).
FORCe
Optional parameter, allows you to delete read-only files, too.
*RST value
n/a
SCPI, Command
Types
Confirmed, no query.
Example:
MMEM:DEL 'C:\TEMP\TEST01.HCP'
Remove file TEST01.HCP from the directory C:\TEMP. The file
must not be read-only; otherwise the additional parameter
FORCe is required.
MMEMory:DELete:CORRection <file_name>'
Deletes a system error correction data set stored in the cal pool (cal group file).
'<file_name>'
String parameter to specify the name of the cal group file to be deleted. Cal group
files must have the extension *.cal. The directory path must not be specified; the
analyzer always uses the default cal pool directory C:\Program
Files\Rohde&Schwarz\Network Analyzer\Calibration\Data.
*RST value
–
SCPI,
Command
Types
Device-specific, no query.
Example:
See MMEMory:LOAD:CORRection
MMEMory:LOAD:CKIT '<file_name>'
Loads cal kit data from a specified NWA cal kit file.
'<file_name>'
String parameter to specify the name and directory of the cal kit file to be loaded. If
no path is specified the analyzer searches the current directory, to be queried with
MMEMory:CDIRectory?.
Note: The loaded file must be a NWA-specific cal kit file with the extension *.calkit.
ZVR cal kit files can be imported using the
[SENSe<Ch>:]CORRection:CKIT:INSTall command. Agilent cal kit files can
be imported manually and converted into *.calkit files.
*RST value
–
SCPI,
Command
Types
Device-specific, no query.