R&S ZVB - Page 808

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 793
Types
Example:
*RST
Reset the analyzer, creating the default trace no. 1 in
channel no. 1.
CALC:MARK ON; MARK:X 1GHz
Create marker no. 1 and place it to 1 GHz.
CALC:MARK2 ON; MARK2:X 2GHz
Create a second marker and place it to 2 GHz.
MMEM:STOR:MARK 'Marker.txt'
Store the marker values to an ASCII file. The file contains
both marker values:
MMEMory:STORe:MDCData <Channel>, '<file_name>'
Stores the correction data for a mixer delay measurement calibration to a specified file. Mixer delay
measurements are controlled using the SENSe<Ch>:FREQuency:MDELay... commands.
<Channel>
Channel number. This parameter is ignored; the data is assigned to a channel
when the file is re-loaded.
*RST value
–
'<file_name>'
String parameter to specify the name and directory of the created calibration file.
The default extension (manual control) for mixer delay calibration files is *.mcal,
although other extensions are allowed. If no path is specified the analyzer uses the
current directory, to be queried with MMEMory:CDIRectory?.
*RST value
–
SCPI,
Command
Types
Device-specific, no query.
Example:
See MMEMory:LOAD:MDCData
MMEMory:STORe:PTRain <Channel>, <Generator>, '<file_name>'
Saves a pulse train definition associated with a specified channel to a pulse train file. Pulse train
definitions are created using the SENSe<Ch>:PULSe:GENerator<Gen>... commands.
<Channel>
Channel number. This parameter is ignored; the data is assigned to a channel
when the file is re-loaded.
*RST value
–
<Generator>
Generator number. In the present firmware version, this number is always 1.
*RST value
1