R&S ZVB - Page 880

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 865
<port_no>
Port number of the analyzer. This numeric suffix is ignored; the active port is
determined by the active trace.
ONCE
Applies the Auto Length function.
*RST value
–
SCPI, Command
Types
Device-specific, no query
Example:
*RST; :CORR:EDEL:AUTO ONCE
Reset the instrument and apply the auto length function to the default trace
(Trc1 in channel 1).
[SENSe<Ch>:]CORRection:EDELay<port_no>:DIELectric <permittivity>
Defines the permittivity for the offset correction at test port <port_no>.
<Ch>
Channel number of the offset-corrected channel
<port_no>
Port number of the analyzer
<permittivity>
Permittivity
Range [def. unit]
1 to +1E+6 []
*RST value
1.00062
SCPI, Command Types
Device-specific, command or query
Example:
See [SENSe<Ch>:]CORRection:EDELay<port_no>:ELENgth
[SENSe<Ch>:]CORRection:EDELay<port_no>:DISTance <length>
Defines the offset parameter for test port <port_no> as a mechanical length.
<Ch>
Channel number of the offset-corrected channel
<port_no>
Port number of the analyzer
<length>
Mechanical length
Range [def. unit]
–3.402823466E+038 m to +3.4028234664E+038 m.
*RST value
0 m [m]
SCPI, Command Types
Device-specific, command or query
Example:
See [SENSe<Ch>:]CORRection:EDELay<port_no>:ELENgth
[SENSe<Ch>:]CORRection:EDELay<port_no>:ELENgth <length>
Defines the offset parameter for test port <port_no> as an electrical length.
<Ch>
Channel number of the offset-corrected channel