R&S ZVB - Page 917

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 902
[SENSe<Ch>:]FREQuency<Pt>:OFFSet:PWAVes <offset>
Defines the constant receiver frequency offset for primed wave quantities relative to the common receiver
frequency.
<Ch>
Channel number.
<Pt>
Test port number of the analyzer.
<offset>
Frequency offset.
Range [def. unit]
Depending on the instrument model [Hz]. The increment (parameters UP or
DOWN) is 1 kHz.
*RST value
0 Hz
SCPI, Command
Types
Device-specific, command or query.
Example:
FREQ:STAR 2GHz; STOP 3 GHz
Define a sweep range between 2 GHz and 3 GHz.
FREQ:OFFS:PWAV 10kHz; WAV 20kHz
Modify the receiver frequency settings.
[SENSe<Ch>:]FREQuency<Pt>:OFFSet:WAVes <offset>
Defines the constant receiver frequency offset for unprimed wave quantities relative to the common
receiver frequency.
The offset for unprimed waves is not displayed in the Port Configuration dialog.
<Ch>
Channel number.
<Pt>
Test port number of the analyzer.
<offset>
Frequency offset.
Range [def. unit]
Depending on the instrument model [Hz]. The increment (parameters UP or
DOWN) is 1 kHz.
*RST value
0 Hz
SCPI, Command
Types
Device-specific, command or query.
Example:
See [SENSe<Ch>:]FREQuency<Pt>:OFFSet:PWAVes
[SENSe<Ch>:]FREQuency:SBANd POSitive | NEGative | AUTO
Defines whether the analyzer measures with a local oscillator frequency LO below or above the RF input
frequency.
In a segmented frequency sweep, it is possible to set the sideband (SBANd) parameter individually for
each segment; see [SENSe<Ch>:]SEGMent<Seg>:DEFine. The [SENSe<Ch>:]FREQuency:SBANd
setting is global and not valid for segmented sweeps. The two sideband settings do not overwrite each
other.