R&S ZVB - Page 967

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 952
Query the sweep time in the new segment.
[SENSe<Ch>:]SEGMent<Seg>:NAME '<segment_name>'
Defines the Name of the sweep segment no. <Seg>.
<Ch>
Channel number
<Seg>
Sweep segment number
'<segment_name>'
Sting parameter defining the segment name.
*RST value
'' (empty string) – a new segment is created without segment name
([SENSe<Ch>:]SEGMent<Seg>:ADD).
SCPI, Command
Types
Device-specific, command or query
Example:
*RST; :SEGM:ADD
Create a new sweep segment no. 1 in channel no. 1 using default settings.
SEGM:NAME 'Passband'
Assign a segment name.
SEGMent:SBANd POSitive
Select LO > RF for the created segment. .
SEGM:SBANd:CONT?
Query whether individual Spur Avoid (LO <> RF) settings for the sweep
segments are enabled. The response is 1.
[SENSe<Ch>:]SEGMent<Seg>:OVERlap <Boolean>
[Deprecated command. not needed on R&S ZVA analyzers]
Queries whether the analyzer supports overlapping sweep segments.
<Ch>
Channel number This suffix is ignored; the command is instrument-specific.
<Seg>
Sweep segment number. This suffix is ignored; the command is instrument-
specific.
<Boolean>
ON | OFF: No effect.
*RST value
ON. If used as a query, the command returns the information that overlapping
sweep segments are supported (ON).
SCPI, Command
Types
Device-specific, command (no effect) or query