Instrument Functions
R&S
®
FSVA/FSV
192Operating Manual 1176.7510.02 ─ 09
Remote command:
SYSTem:FIRMware:UPDate on page 966
Option Licenses
Opens a submenu to install options. For details on options refer to the Quick Start
Guide, chapter 3 "Firmware Update and Installation of Firmware Options".
The submenu contains the following commands:
●
"Install Option" on page 192
●
"Install Option by XML" on page 192
Only user accounts with administrator rights are able to install options.
Install Option ← Option Licenses
Opens an edit dialog box to enter the license key for the option that you want to install.
If an option is about to expire, a message box is displayed to inform you. You can then
use this softkey to enter a new license key.
If an option has already expired, a message box appears for you to confirm. In this
case, all instrument functions are unavailable (including remote control) until the
R&S FSVA/FSV is rebooted. You must then use the "Install Option" softkey to enter
the new license key.
For more information about the option in question refer to the System Info softkey in
the "Setup" menu.
Only user accounts with administrator rights are able to install options.
Install Option by XML ← Option Licenses
Opens an edit dialog to install an additional option to the R&S FSVA/FSV using an
XML file. Enter or browse for the name of an XML file on the instrument that contains
the option key and press "Select".
Only user accounts with administrator rights are able to install options.
Application Setup Recovery
Controls instrument behavior when switching between measurement applications, e.g.
from "Spectrum" to "Analog Demod" and back.
If this softkey is activated, the current instrument settings are stored when you switch
to a different application. When you switch back to the previous application, the corre-
sponding instrument settings are restored. Thus, the settings of the individual applica-
tions are independant of each other.
If the softkey is deactivated (default), only a few parameters of the current instrument
setting are passed between applications (e.g. center frequency, level settings).
Note that this setting is not deactivated during a preset operation, i.e. you must deacti-
vate it manually, if necessary.
Remote command:
SYSTem:APPLication:SRECovery[:STATe] on page 961
Service
Opens a submenu that contains additional functions for maintenance and/or trouble-
shooting.
General Settings, Printout and Instrument Settings
To Next Page
Loading...
