Rohde & Schwarz FSVA - Page 669

Remote Control
R&S
®
FSVA/FSV
669Operating Manual 1176.7510.02 ─ 09
Manual operation: See "Next Peak" on page 302
See "Next Mode" on page 304
See "Search Mode for Next Peak in X Direction" on page 305
CALCulate<n>:MARKer<m>:MAXimum:RIGHt
This command positions a marker to the next smaller trace maximum on the right of
the current value (i.e. in ascending X values).
If no next smaller maximum value is found on the trace (level spacing to adjacent val-
ues < peak excursion), an execution error (error code: -200) is produced.
In "Spectrogram" mode, this command positions the specified marker on the next peak
level of the x-axis. The search includes only the data to the right of the current marker
position in the current frame. It does not change the position of the delta marker on the
y-axis.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Example:
CALC:MARK2:MAX:RIGH
Positions marker 2 to the next lower maximum value to the right
of the current value.
Usage: Event
Manual operation: See "Next Mode" on page 304
See "Search Mode for Next Peak in X Direction" on page 305
CALCulate<n>:MARKer<m>:MINimum[:PEAK]
This command positions the marker on the current trace minimum.
The corresponding marker is activated first or switched to marker mode, if necessary.
If no minimum value is found on the trace (level spacing to adjacent values < peak
excursion), an execution error (error code: -200) is produced.
In "Spectrogram" mode, this command positions the specified marker on the current
minimum level of the x-axis. The search is performed within the current frame. It does
not change the position of the marker on the y-axis / frames.
Suffix:
<n>
.
Selects the measurement window.
<m> depends on mode
Selects the marker.
Example:
CALC:MARK2:MIN
Positions marker 2 to the minimum value of the trace.
Usage: Event
Remote Control – Commands