Rohde & Schwarz FSVA - Page 668

Remote Control
R&S
®
FSVA/FSV
668Operating Manual 1176.7510.02 ─ 09
Example:
CALC:MARK:MAX:AUTO ON
Activates the automatic peak search function for marker 1 at the
end of each particular sweep.
Usage: Event
Manual operation: See "Auto Max Peak/Auto Min Peak" on page 303
CALCulate<n>:MARKer<m>:MAXimum:LEFT
This command positions a marker to the next smaller trace maximum on the left of the
current position (i.e. in descending X values).
If no next smaller maximum value is found on the trace (level spacing to adjacent val-
ues < peak excursion), an execution error (error code: -200) is produced.
In "Spectrogram" mode, this command positions the specified marker on the next peak
level of the x-axis. The search includes only the data to the left of the current marker
position in the current frame. It does not change the position of the marker on the y-
axis.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Example:
CALC:MARK2:MAX:LEFT
Positions marker 2 to the next lower maximum value to the left
of the current value.
Usage: Event
Manual operation: See "Next Mode" on page 304
See "Search Mode for Next Peak in X Direction" on page 305
CALCulate<n>:MARKer<m>:MAXimum:NEXT
This command positions the marker to the next smaller trace maximum.
If no next smaller maximum value is found on the trace (level spacing to adjacent val-
ues < peak excursion), an execution error (error code: -200) is produced.
In "Spectrogram" mode, this command positions the specified marker on the next peak
level of the x-axis. The search includes the data in both directions of the current marker
position in the current frame. It does not change the position of the marker on the y-
axis.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Example:
CALC:MARK2:MAX:NEXT
Positions marker 2 to the next lower maximum value.
Usage: Event
Remote Control – Commands