Remote Control
R&S
®
FSVA/FSV
674Operating Manual 1176.7510.02 ─ 09
Example:
CALC:MARK2:X 1.7MHz
Positions marker 2 to frequency 1.7 MHz.
Manual operation: See "Marker 1 / Marker 2 / Marker 3 / … Marker 16,/ Marker
Norm/Delta" on page 280
CALCulate<n>:MARKer<m>:X:SLIMits[:STATe] <State>
This command turns marker search limits on and off.
If the power measurement in zero span is active, this command limits the evaluation
range on the trace.
Suffix:
<n>
.
Selects the measurement window.
<m> marker
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:MARK:X:SLIM ON
Switches on search limitation.
Manual operation: See "Search Limits" on page 303
See "Search Lim Off" on page 304
See "Limits (On/Off)" on page 385
CALCulate<n>:MARKer<m>:X:SLIMits:LEFT <Limit>
This command sets the left limit of the marker search range.
If the power measurement in zero span is active, this command limits the evaluation
range to the trace.
Note: The function is only available if the search limit for marker and delta marker is
switched on (see CALCulate<n>:MARKer<m>:X:SLIMits[:STATe]).
Suffix:
<n>
.
Selects the measurement window.
<m> irrelevant
Parameters:
<Limit> The value range depends on the span or sweep time.
The unit is Hz for frequency domain measurements and s for
time domain measurements.
Range: 0 to MAX
*RST: left diagram border
Example:
CALC:MARK:X:SLIM ON
Switches the search limit function on.
CALC:MARK:X:SLIM:LEFT 10MHz
Sets the left limit of the search range to 10 MHz.
Remote Control – Commands
To Next Page
Loading...
