Rohde & Schwarz FSVA - Page 963

Remote Control
R&S
®
FSVA/FSV
963Operating Manual 1176.7510.02 ─ 09
SYSTem:COMMunicate:PRINter:ENUMerate[:NEXT]?
This command queries the name of the next printer installed under Windows operating
system. After all available printer names have been output, an empty string enclosed
by quotation marks (") is output for the next query. Further queries are answered by a
query error.
The SYSTem:COMMunicate:PRINter:ENUMerate:FIRSt? command should be
sent previously to return to the beginning of the printer list and query the name of the
first printer.
Example:
SYST:COMM:PRIN:ENUM?
Usage: Query only
Manual operation: See "Device Setup" on page 212
SYSTem:COMMunicate:PRINter:SELect <1|2>
<PrinterName>
This command selects one of the printers configured under Windows operating sys-
tem, including the associated output destination.
The specified printer name must be a string (entered in quotes) as returned by the
commands
SYSTem:COMMunicate:PRINter:ENUMerate:FIRSt? or
SYSTem:COMMunicate:PRINter:ENUMerate[:NEXT]?
The HCOPy:DESTination<1|2> on page 932 command is used to select an output
medium other than the default one.
Parameters:
<PrinterName> "<printer_name>"
*RST: NONE
Example:
SYST:COMM:PRIN:SEL "LASER on LPT1"
SYSTem:COMMunicate:TCPip:CONTrol?
This command outputs the control port for the LAN socket connection. An error indi-
cates that the socket connection is not supported.
Example:
SYST:COMM:TCP:CONT?
Usage: Query only
SYSTem:COMPatible <Mode>
Sets the device in a state compatible to previous R&S signal analyzers, e.g. regarding
the number of sweep points.
Parameters:
<Mode> DEFault | FSU | FSP
Remote Control – Commands