Rohde & Schwarz R&S SMB100B - Page 259

General instrument functions
R&S
®
SMB100B
259User Manual 1178.3711.02 ─ 08
How to:
●
"Changing the default user password of the instrument" on page 261.
●
"Changing the default security password" on page 261.
User Name
Indicates the user name used for access to the Linux operating system and valid for
VNC, FTP and SMB (Samba) access.
User Password
Access: select "System Config > Setup > Security > Security > Password Management
> User Password".
Allows you to change and confirm the user password.
Old Password ← User Password
Enters the current user password. The default password is "instrument".
Note: We recommend that you change the default password before connecting the
instrument to a network.
How to:
●
"Changing the default user password of the instrument" on page 261.
●
"Changing the default security password" on page 261.
Note: Note that you cannot reset the password to factory state.
If you encounter problems with the password, contact the Rohde & Schwarz customer
support, see Chapter 13.9, "Contacting customer support", on page 585.
New Password ← User Password
Enters the new user password.
The security password can contain decimal characters only.
Confirm Password ← User Password
Confirms the new user password by repeating.
How to:
●
"Changing the default user password of the instrument" on page 261.
Using the security settings