Rohde & Schwarz R&S SMB100B - Page 301

Network operation and remote control
R&S
®
SMB100B
301User Manual 1178.3711.02 ─ 08
5. Select "User Settings".
The "Configure SNMP User for HUMS" dialog provides an overview of all defined
SNMP users and their profiles. With the "Add" and "Delete All" controls, you can
add or remove users.
Settings
Add..............................................................................................................................301
Delete All.....................................................................................................................301
User table....................................................................................................................301
└ Edit................................................................................................................302
└ Name............................................................................................................ 302
└ Prefix.............................................................................................................303
└ Level............................................................................................................. 303
└ Delete............................................................................................................303
Add SNMP User for HUMS.........................................................................................303
└ SNMP User Name........................................................................................ 303
└ SNMP User Prefix.........................................................................................303
└ SNMP User Level......................................................................................... 304
└ SNMP User Public Passphrase.................................................................... 304
└ SNMP User Encrypted Passphrase..............................................................304
└ Add / Update.................................................................................................304
Add
Accesses the "Add SNMP User for HUMS" dialog.
In this dialog, you can define a user and its profile, see "Add SNMP User for HUMS"
on page 303.
Delete All
Removes all users from the list.
Remote command:
SYSTem:COMMunicate:SNMP:USM:USER:DELete:ALL on page 381
User table
Lists all defined SNMP users.
Remote access settings