Remote control commands
R&S
®
SMB100B
440User Manual 1178.3711.02 ─ 08
Manual operation: See " Program Service Name" on page 86
See "Program Identification" on page 86
[:SOURce]:STEReo:STATe <State>
Activates/deactivates stereo modulation.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example"Activating stereo modulation" on page 438.
Manual operation: See "State" on page 80
[:SOURce]:STEReo[:DEViation]
<Deviation>
Sets the MPX (Multiplex stereo signal) deviation.
Parameters:
<Deviation> integer
Range: 0 to depends on instrument hardware
*RST: 40 kHz
Example: See Example"Activating stereo modulation" on page 438.
Manual operation: See "FM Deviation" on page 80
[:SOURce]:STEReo:AUDio:MODE <Mode>
Selects the generated identifiers of the AUDio signal.
Parameters:
<Mode> LEFT | RIGHt | RELeft | REMLeft | RNELeft
LEFT
A mono signal containing the left channel is generated/fed in.
RIGHt
A mono signal containing the right channel is generated/fed in.
RELeft
A stereo signal with right and left channel is generated/fed in.
The channels have the same frequency and phase.
REMLeft
The signal on the left external audio input is used for both chan-
nels, left and right. The right channel is inverted.
RNELeft
(External source only)
A stereo signal containing different, independent right and left
channels is feed in. It is possible, for example, to feed a fixed
audio frequency to the first channel while a frequency sweep is
being performed in the second channel.
SOURce subsystem
To Next Page
Loading...
