Rohde & Schwarz R&S SMB100B - Page 439

Remote control commands
R&S
®
SMB100B
439User Manual 1178.3711.02 ─ 08
// Configure and activate ARI
STEReo:ARI 2800
SOURce:STEReo:ARI:TYPE BK
STEReo:ARI:BK C
SOURce:Stereo:ARI:STATe 1
//Configure and activate RDS
STEReo:RDS 1200
SOURce:STEReo:RDS:DATaset DS3
SOURce:STEReo:RDS:TRAFfic:PROGram:STATe 1
SOURce:STEReo:RDS:TRAFfic:ANNouncement:STATe 1
STEReo:RDS:STATe 1
// Activate the signal output
SOURce:STEReo:STATe 1
[:SOURce]:STEReo:DIRect.............................................................................................439
[:SOURce]:STEReo:STATe............................................................................................. 440
[:SOURce]:STEReo[:DEViation].......................................................................................440
[:SOURce]:STEReo:AUDio:MODE...................................................................................440
[:SOURce]:STEReo:SOURce..........................................................................................441
[:SOURce]:STEReo:EXTernal:IMPedance........................................................................ 441
[:SOURce]:STEReo:MMF............................................................................................... 441
[:SOURce]:STEReo:AUDio:PREemphasis........................................................................442
[:SOURce]:STEReo:AUDio:PREemphasis:STATe..............................................................442
[:SOURce]:STEReo:PILot:STATe.....................................................................................442
[:SOURce]:STEReo:PILot[:DEViation].............................................................................. 442
[:SOURce]:STEReo:PILot:PHASe....................................................................................443
[:SOURce]:STEReo:ARI:STATe....................................................................................... 443
[:SOURce]:STEReo:ARI[:DEViation]................................................................................ 443
[:SOURce]:STEReo:ARI:TYPE:STATe..............................................................................444
[:SOURce]:STEReo:ARI:TYPE........................................................................................444
[:SOURce]:STEReo:ARI:BK[:CODE]................................................................................444
[:SOURce]:STEReo:RDS:STATe......................................................................................445
[:SOURce]:STEReo:RDS[:DEViation]...............................................................................445
[:SOURce]:STEReo:RDS:DATaset...................................................................................445
[:SOURce]:STEReo:RDS:TRAFfic:PROGram[:STATe]....................................................... 445
[:SOURce]:STEReo:RDS:TRAFfic:ANNouncement[:STATe]................................................446
[:SOURce]:STEReo:DIRect <Direct>
Sends a R&S SMB100B command string to the stereo coder.
The direct commands offer extended settings possibilities for the stereo coder, see
Chapter 12.21, "Direct commands for the stereo/rds coder option R&S SMBB-B5",
on page 551.
Parameters:
<Direct> string
Example: See Example"Activating stereo modulation" on page 438.
SOURce subsystem