Rohde & Schwarz R&S SMB100B - Page 467

Remote control commands
R&S
®
SMB100B
467User Manual 1178.3711.02 ─ 08
Parameters:
<Offset> float
Range: depends on lfo voltage
Increment: 0.001
*RST: 0
Example: See Example"Configuring the LF generator" on page 462.
Manual operation: See "DC-Offset" on page 107
[:SOURce]:LFOutput<ch>:SOURce <Source>
Determines the LF signal to be synchronized, when monitoring is enabled.
Parameters:
<Source> LF1 | LF2 | NOISe | AM | FMPM | EXT1
LF1|LF2
Selects an internally generated LF signal.
NOISe
Selects an internally generated noise signal.
EXT1
Selects an externally supplied LF signal
AM
Selects the AM signal.
FMPM
Selects the signal also used by the frequency or phase modula-
tions.
*RST:
LF1
Example: See Example"Configuring the LF generator" on page 462.
Manual operation: See "Source" on page 106
[:SOURce]:LFOutput:SIMPedance <SImpedance>
Selects the impedance of the LF output.
Parameters:
<SImpedance> G600 | G50
*RST: G50
Example:
SOURce:LFOutput:SIMPedance G600
Sets the output impedance of the LF generator to 600 Ohm.
Manual operation: See "Source Impedance" on page 107
[:SOURce]:LFOutput<ch>:SOURce:PATH <SourPath>
Determines the path of the LF output source.
SOURce subsystem