Rohde & Schwarz R&S SMB100B - Page 468

Remote control commands
R&S
®
SMB100B
468User Manual 1178.3711.02 ─ 08
Parameters:
<SourPath> A | B
*RST: A
Example:
LFO:SOUR:PATH?
Queries the currently set path for the LF output signal source.
[:SOURce]:LFOutput:VOLTage <Voltage>
Sets the voltage of the LF output.
Parameters:
<Voltage> float
Range: dynamic (see data sheet)
Increment: 0.001
*RST: 1
Example:
SOURce:LFOutput:VOLTage 1.5
[:SOURce<hw>]:LFOutput<ch>:SHAPe <Shape>
Selects the waveform shape of the LF signal.
Parameters:
<Shape> SINE | SQUare | PULSe | TRIangle | TRAPeze
*RST: SINE
Example: See Example"Configuring the LF generator" on page 462.
Options: TRIangle|TRAPeze require R&S SMBB-K24
Manual operation: See "LF Gen Shape" on page 81
See "Shape" on page 100
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:DCYCle <DCycle>
Sets the duty cycle for the shape pulse.
Parameters:
<DCycle> float
Range: 1E-6 to 100
Increment: 1E-6
*RST: 50
Default unit: PCT
Example: See Example"Configuring the LF generator" on page 462.
Manual operation: See "Pulse Duty Cycle" on page 102
SOURce subsystem