Rohde & Schwarz R&S SMB100B - Page 543

Remote control commands
R&S
®
SMB100B
543User Manual 1178.3711.02 ─ 08
:SYSTem:FILes:TEMPorary:DELete
Deletes the temporary files from the internal memory.
Example:
:SYSTem:FILes:TEMPorary:DELete
// temporary files are removed
Usage: Event
12.17 STATus subsystem
This system contains the commands for the status reporting system. See also Chap-
ter 11.4, "Status reporting system", on page 276 for detailed information.
*RST on page 354 has no effect on the status registers.
Value ranges
●
Queries return the current value of the respective register, which permits a check of
the device status.
Return values: A decimal value in the range 0 to 32767 (=2
15
-1)
●
The configuration commands set the respective register thus determining which
status changes of the R&S SMB100B cause the status registers to be changed.
Setting values: A decimal value in the range 0 to 32767 (=2
15
-1)
:STATus:OPERation:CONDition?.....................................................................................543
:STATus:OPERation:ENABle...........................................................................................544
:STATus:OPERation[:EVENt]...........................................................................................544
:STATus:OPERation:NTRansition.................................................................................... 544
:STATus:OPERation:PTRansition.....................................................................................544
:STATus:PRESet............................................................................................................545
:STATus:QUEStionable:CONDition.................................................................................. 545
:STATus:QUEStionable:ENABle.......................................................................................545
:STATus:QUEStionable[:EVENt]...................................................................................... 545
:STATus:QUEStionable:NTRansition................................................................................546
:STATus:QUEStionable:PTRansition................................................................................ 546
:STATus:QUEue[:NEXT]?................................................................................................546
:STATus:OPERation:CONDition?
Quieries the content of the CONDition part of the STATus:OPERation register.
This part contains information on the action currently being performed in the instru-
ment. The content is not deleted after being read out because it indicates the current
hardware status.
Return values:
<Condition> string
Example:
:STATus:OPERation:CONDition?
Usage: Query only
STATus subsystem