Rohde & Schwarz R&S SMB100B - Page 547

Remote control commands
R&S
®
SMB100B
547User Manual 1178.3711.02 ─ 08
12.18 TEST subsystem
The TEST subsystem contains the commands for performing test routines directly at
the hardware assemblies.
The selftetst responses with a 0 if the test is performed successfully, otherwise a value
other than 0 is returned. None of the commands of this system has a *RST value.
:TEST<hw>:ALL:STARt.................................................................................................. 547
:TEST<hw>:ALL:RESult?................................................................................................547
:TEST<hw>:ALL:STARt
Usage:
Event
Starts the selftest. Use the command
:TEST<hw>:ALL:RESult? to query the result.
:TEST<hw>:ALL:RESult?
Queries the result of the performed selftest. Start the selftest with :TEST<hw>:ALL:
STARt.
Return values:
<Result> 0 | 1 | RUNning | STOPped
*RST: STOPped
Usage: Query only
12.19 TRIGger subsystem
The TRIGger system contains the commands for selecting the trigger source for the
RF and LF sweep.
You can work with an internal or with an externally applied trigger signal. In this case,
use the commands in the SOURce:INPut subsystem to configure the signal.
The trigger system of the R&S SMB100B is a simplified implementation of the SCPI
trigger system. The TRIGger system differs from the SCPI system as follows:
●
No INITiate command; the instrument behaves as if INITiate:CONTinuous
ON were set.
●
Under TRIGger several sweep subsystems exist.
●
The trigger source names correspond directly to the various settings of manual
control. SCPI uses different names which are also accepted by the instrument. The
SCPI names should be used if compatibility is an important consideration.
In addition to these commands, see more trigger-related commands in the modulation
and RF signal subsystems.
TRIGger subsystem