Rohde & Schwarz R&S SMB100B - Page 555

Remote control commands
R&S
®
SMB100B
555User Manual 1178.3711.02 ─ 08
Example:
STEReo:DIRect "1A=01,0123456789,1FFFFFFFFF"
Fills a queue with the data "0123456789,1FFFFFFFFF". The
data is sent in consecutive order in group 1A after group 1A is
added to the group sequence.
Query the data of group 1A
STEReo:DIRect? "1A"
Response: "01,0123456789,1FFFFFFFFF"
STEReo:DIRect "AF=<A>,<Freq#1>,<Freq#2>,..."
STEReo:DIRect? "AF<z>"
Defines an alternative frequency list.
A maximum of five AF lists with max. 25 frequencies per list can be created.
Parameters:
<Freq> xxx.x
Sets the alternative frequencies as ASCII coded decimal num-
bers.
If list <z> is not available, the response is ().
Range: 87.6 to 107.9
Setting parameters:
<A> N
New AF list
+
AF list to be added.
Query parameters:
<z> AF list to be read.
Range: 1 to 5
Example:
STEReo:DIRect "AF=N,97.4,98.3"
Defines an alternative frequency list, the alternative frequencies
97.4 and 98.3 are inserted.
STEReo:DIRect? "AF1"
Response: "97.4,98.3"
STEReo:DIRect "AF=N"
Deletes all frequency lists.
STEReo:DIRect "ARI=<State>"
STEReo:DIRect? "ARI"
(for documentation reasons only)
Activates ARI signal transmission.
Use the command [:SOURce]:STEReo:ARI:STATe instead.
Setting parameters:
<State> 0 | 1
Direct commands for the stereo/rds coder option R&S SMBB-B5