Rohde & Schwarz R&S SMB100B - Page 556

Remote control commands
R&S
®
SMB100B
556User Manual 1178.3711.02 ─ 08
Example:
STEReo:DIRect "ARI=0"
Deactivates ARI signal transmission.
STEReo:DIRect? "ARI"
Response: "0"
STEReo:DIRect "ARI-DEV=<Deviation>"
STEReo:DIRect? "ARI-DEV"
(for documentation reasons only)
Sets the frequency deviation of the ARI signal (max. deviation).
Use the command [:SOURce]:STEReo:ARI[:DEViation] instead.
Setting parameters:
<Deviation> Sets the frequency deviation.
Note: Always set a four-digit value. Specify leading zeros, if any.
Range: 0000 to 1000 (ASCII coded decimal numbers),
corresponding to 0 Hz to 10 kHz
Example:
STEReo:DIRect "ARI-DEV=1000
Sets the ARI frequency deviation to 10 kHz.
STEReo:DIRect? "ARI"
Response: "1000"
STEReo:DIRect "ARI-ID=<Id>"
STEReo:DIRect? "ARI-ID"
(for documentation reasons only)
Selects the ARI identification.
Use the command [:SOURce]:STEReo:ARI:TYPE instead.
Parameters:
<Id> 0 | 1 | 2 | 3
0
Off
1
DK (traffic announcement identification)
2
BK (area identification)
3
DK and BK (traffic announcement identification and area identifi-
cation)
Example:
STEReo:DIRect "ARI-ID=0"
Deactivates the ARI identification.
STEReo:DIRect? "ARI-ID"
Response: "0"
Direct commands for the stereo/rds coder option R&S SMBB-B5