Rohde & Schwarz R&S SMB100B - Page 557

Remote control commands
R&S
®
SMB100B
557User Manual 1178.3711.02 ─ 08
STEReo:DIRect "BIN=<x>"
Defines and sends, or queries, binary test patterns. The BIN command causes the
Stereo/RDS Coder to send periodic binary bit patterns instead of RDS data.
Parameters:
<x> 0
Binary mode OFF
1
00000000...,
2
11111111...,
3
01010101...,
4
11001100...
Example:
STEReo:DIRect "BIN=2"
The binary test pattern is set to "2" so that only "1s" are transmit-
ted.
STEReo:DIRect "BK=<Code>"
STEReo:DIRect? "BK"
(for documentation reasons only)
Sets the ARI area identification.
Use the command [:SOURce]:STEReo:ARI:BK[:CODE] instead.
Parameters:
<Code> A | B | C | D | E | F
Example:
STEReo:DIRect "BK=E"
The ARI area identification is set to "E".
STEReo:DIRect? "BK"
Response: "E"
STEReo:DIRect "CT= <Hour>:<Min>:<Sec>,<Day>.<Month>.<Year>"
STEReo:DIRect? "CT"
Sets and activates transmission of the real-time clock.
Note: The CT data is transmitted in group 4A. Setting the real-time clock (CT com-
mand) automatically adds group 4A to the group sequence.
Do not manually add group 4A to, or remove group 4A from, the group sequence.
To remove group 4A from the group sequence, use the command STEReo:DIRect.
Setting parameters:
<Hour>:<Min>:<Sec> Range: 00:00:00 to 23:59:59
Direct commands for the stereo/rds coder option R&S SMBB-B5