Rohde & Schwarz R&S SMB100B - Page 558

Remote control commands
R&S
®
SMB100B
558User Manual 1178.3711.02 ─ 08
<Day>.<Month>.<Year>Range: 01.01.00 to 31.12.85
Example:
STEReo:DIRect "CT=20:30:59,01.08.03"
The real-time clock is set.
STEReo:DIRect? "CT"
Response: "20:31:06,01.08.03"
STEReo:DIRect "CT=off"
Deactivates transmission of the real-time clock signal in the RDS signal.
Note: This command is used to remove group 4A from the group sequence. Do not
manually remove group 4A from the group sequence.
Example:
STEReo:DIRect "CT=off"
The real-time clock signal is no longer transmitted in the RDS
signal.
Usage: Setting only
STEReo:DIRect "DI=<x>"
STEReo:DIRect? "DI"
Sets or reads the decoder information (DI).
This command reads, and if necessary changes, the current decoder operating mode
(mono, stereo, etc.).
Parameters:
<x> Range: 0 to F (ASCII coded hexadecimal numbers)
Example:
STEReo:DIRect "DI=4"
STEReo:DIRect "DS=<x>"
STEReo:DIRect? "DS"
(for documentation reasons only)
Selects/activates a storage area in the Stereo/RDS Coder.
If activated, the settings stored in the selected area can be loaded.
Use the command [:SOURce]:STEReo:RDS:DATaset instead.
Parameters:
<x> Range: 1 to 5
Example:
STEReo:DIRect "DS=2"
Storage area 2 is activated.
Direct commands for the stereo/rds coder option R&S SMBB-B5