Rohde & Schwarz R&S SMB100B - Page 561

Remote control commands
R&S
®
SMB100B
561User Manual 1178.3711.02 ─ 08
Example:
STEReo:DIRect "EON-PI=1000"
Creates an EON with PI=1000.
STEReo:DIRect "EON-PS=<PI>,<PS>"
STEReo:DIRect? "EON-PS,<PI>"
Enhanced Other Networks: Sets the program service (PS) name for the EON with the
selected <PI>.
Parameters:
<PI> Range: 0000 to FFFF (ASCII coded hexadecimal num-
bers)
Setting parameters:
<PS> 8 ASCII characters
Note: Always set an eight-digit value. Blank spaces, if any, must
also be entered.
Example:
STEReo:DIRect "EON-PS=1000,Test 123"
Sets the program service name for the EON with PI=1000 to
"Test 123".
STEReo:DIRect "EON-PTY=<PI>,<PTY>"
STEReo:DIRect? "EON-PTY,<PI>"
Enhanced Other Networks: Sets the program type (PTY) for the EON with the selected
<PI>.
Parameters:
<PI> Range: 0000 to FFFF (ASCII coded hexadecimal num-
bers)
Setting parameters:
<PTY> Range: 00 to 31 (ASCII coded decimal numbers)
Example:
STEReo:DIRect "EON-PTY=1000,10"
Sets the program type for the EON with PI=1000 to "10".
STEReo:DIRect "EON-TA=<PI>,<TA>"
STEReo:DIRect? "EON-TA,<PI>"
Enhanced Other Networks: Sets the TA flag for the EON with the selected <PI>.
Parameters:
<PI> Range: 0000 to FFFF (ASCII coded hexadecimal num-
bers)
Setting parameters:
<TA> 0 | 1
Example:
STEReo:DIRect "EON-TA=1000,1"
Sets the TA flag for the EON with PI=1000 to "1".
Direct commands for the stereo/rds coder option R&S SMBB-B5