Rohde & Schwarz R&S SMB100B - Page 564

Remote control commands
R&S
®
SMB100B
564User Manual 1178.3711.02 ─ 08
Example:
STEReo:DIRect "MASK_STATE=1"
With the command MASK_STATE=1, a sequence of errored
groups as defined by the MASK command is retransmitted once
if the number of groups to be masked is other than zero. Then,
MASK_STATE is automatically set to "0".
If the number of groups to be masked is equal to zero in the
MASK command (which means continuous error transmission),
the masking function can be switched off with MASK_STATE=0.
Example:
STEReo:DIRect? "MASK_STATE"
Response: "1"
The MASK_STATE query provides information whether the RDS
data stream is linked to an error mask.
STEReo:DIRect
"MODE=<EMODE>"
STEReo:DIRect? "MODE"
(for documentation reasons only)
Sets one of various transmission modes.
Use the command [:SOURce]:STEReo:AUDio:MODE instead.
Setting parameters:
<EMODE> 1 | 2 | 3 | 4 | 5
1
L: Signal in left channel only
2
R: Signal in right channel only
3
Signal of equal frequency and phase in left and right channel
4
Signal of equal frequency and opposite phase in left and right
channel
5
Different, independent signals in left and right channel
(5 is not possible if the internal LF generator is selected as
source (SRC = LFGen)).
Example:
STEReo:DIRect "MODE=1"
Only the signal of the left channel is transmitted.
STEReo:DIRect "MS=<Flag>"
STEReo:DIRect? "MS"
Sets or reads the music/speech flag.
The flag signals whether music or speech is being transmitted.
Setting parameters:
<Flag> M | S
Direct commands for the stereo/rds coder option R&S SMBB-B5