Rohde & Schwarz R&S SMB100B - Page 565

Remote control commands
R&S
®
SMB100B
565User Manual 1178.3711.02 ─ 08
Example:
STEReo:DIRect "MS=M"
The music/speech flag is set to "M", which signals that music is
transmitted.
STEReo:DIRect "MPX-DEV=<Deviation>"
STEReo:DIRect? "MPX-DEV"
(for documentation reasons only)
Sets the MPX frequency deviation (max. deviation).
Use the the command [:SOURce]:STEReo[:DEViation] instead.
Setting parameters:
<Deviation> Note: Always set a four-digit value. Leading zeros, if any, must
also be specified.
Range: 00000 to 10000 (ASCII coded decimal numbers),
corresponding to 0 Hz to 100 kHz
Example:
STEReo:DIRect "MPX-DEV=00201"
Sets the MPX frequency deviation to 2.01 kHz.
STEReo:DIRect "PI=<PI>"
STEReo:DIRect? "PI"
Sets or reads the RDS program identification (PI) code.
Setting parameters:
<PI> Note: Always set a four-digit value. Add leading zeros, if any.
Range: 0000 to FFFF (ASCII coded hexadecimal num-
bers)
Example:
STEReo:DIRect "PI=1234"
The program identification code to be transmitted is set to
"1234".
STEReo:DIRect "PIL=<State>"
STEReo:DIRect? "PIL"
(for documentation reasons only)
Activates/deactivates the pilot tone.
Use the command [:SOURce]:STEReo:PILot:STATe instead.
Setting parameters:
<State> 0 | 1
Example:
STEReo:DIRect "PIL=1"
The pilot tone is activated.
Direct commands for the stereo/rds coder option R&S SMBB-B5