Rohde & Schwarz R&S SMB100B - Page 566

Remote control commands
R&S
®
SMB100B
566User Manual 1178.3711.02 ─ 08
STEReo:DIRect "PIL-DEV=<Deviation>"
STEReo:DIRect? "PIL-DEV"
(for documentation reasons only)
Sets the pilot tone frequency deviation (max. deviation).
Use the command [:SOURce]:STEReo:PILot[:DEViation] instead.
Setting parameters:
<Deviation> Note: Always set a four-digit value. Add leading zeros, if any.
Range: 0000 to 1000 (ASCII coded decimal numbers),
corresponding to 0 Hz to 10 kHz
Example:
STEReo:DIRect "PIL-DEV=1000"
Sets the frequency deviation of the pilot tone to 10 kHz.
STEReo:DIRect
"PIL-PH=<Phase>"
STEReo:DIRect? "PIL-PH"
(for documentation reasons only)
Sets the pilot tone phase.
Use the command [:SOURce]:STEReo:PILot:PHASe instead.
Setting parameters:
<Phase> Note: Always set a two-digit value with a sign ("+" or "-") in front
of it. Add leading zeros, if any.
Range: -5.0 to +5.0 (ASCII coded decimal numbers), cor-
responding to ±5.0
Example:
STEReo:DIRect "PIL-PH=-33"
Sets the pilot tone phase.
STEReo:DIRect "PRE=<Preemphasis>"
STEReo:DIRect? "PRE"
(for documentation reasons only)
Sets one of various preemphasis options.
Use the commands [:SOURce]:STEReo:AUDio:PREemphasis:STATe and [:
SOURce]:STEReo:AUDio:PREemphasis instead.
Setting parameters:
<Preemphasis> 0 | 1 | 2
0
Off
1
50 us
2
75 us
Direct commands for the stereo/rds coder option R&S SMBB-B5