Rohde & Schwarz R&S SMB100B - Page 567

Remote control commands
R&S
®
SMB100B
567User Manual 1178.3711.02 ─ 08
Example:
STEReo:DIRect "PRE=1"
The preemphasis is set to 50 us.
STEReo:DIRect "PRESET"
Sets the default settings in accordance with specifications.
Example:
STEReo:DIRect "PRESET"
Usage: Event
STEReo:DIRect "PS=<PS>"
STEReo:DIRect? "PS"
Sets or reads the RDS program service (PS) name.
Setting parameters:
<PS> 8 ASCII characters
Note: Always set an eight-digit value. Blank spaces, if any, must
also be entered.
Special characters in the program service name are entered with
a leading back slash (\) followed by the decimal code of the spe-
cial character according to table E1 of CENELEC.
Example:
STEReo:DIRect "RT=02,0,test text with \217"
Sets the program service name. 217 denotes the German letter
ü.
STEReo:DIRect "PS-TABLE=<Table>"
STEReo:DIRect? "PS-TABLE"
Selects the character set table used for the display of the RDS program service (PS)
name in the receiver.
The information concerning the character set is transmitted in segment 0 of the PS.
Segment 0 is repeatedly transmitted if the value for PS-TABLE > 0. For PS-TABLE = 0
no information concerning the character set is transmitted.
Setting parameters:
<Table> 0 | 1 | 2 | 3
0
No information concerning the character set table in the PS
1
Table E.1 is used.
2
Table E.2 is used.
3
Table E.3 is used.
Direct commands for the stereo/rds coder option R&S SMBB-B5