Remote control commands
R&S
®
SMB100B
568User Manual 1178.3711.02 ─ 08
Example:
STEReo:DIRect "PS-TABLE=2"
The information concerning the character set is transmitted in
segment 0 of the PS in group 0A. To this end, segment 0 is
transmitted repeatedly. At the first transmission segment 0 con-
tains the information about the character set, at the second
transmission segment 0 contains the first two characters of the
PS.
STEReo:DIRect "PTY=<PTY>"
STEReo:DIRect? "PTY"
Sets or reads the program type (PTY).
Setting parameters:
<PTY> Note: Always set a two-digit value. Add leading zero, if any.
Range: 00 to 31 (ASCII coded decimal numbers)
Example:
STEReo:DIRect "PTY=08"
Sets the program type.
STEReo:DIRect "PTYN=<PTYN>"
STEReo:DIRect? "PTYN"
Sets or reads the RDS program type (PTY) name.
Setting parameters:
<PTYN> 8 ASCII characters
Note: Always set an eight-digit value. Add blank spaces, if any.
Example:
STEReo:DIRect "PTYN=Football"
Sets the program type name.
STEReo:DIRect "GS=0A,10A”
Group 10A is activated in addition to group 0A.
The specified program type name is transmitted.
STEReo:DIRect "RDS=<State>"
STEReo:DIRect? "RDS"
(for documentation reasons only)
Switches RDS on or off.
Use the command [:SOURce]:STEReo:RDS:STATe instead.
Setting parameters:
<State> 0 | 1
Example:
STEReo:DIRect "RDS=1"
Activates RDS.
Direct commands for the stereo/rds coder option R&S SMBB-B5
To Next Page
Loading...
