Rohde & Schwarz R&S SMB100B - Page 569

Remote control commands
R&S
®
SMB100B
569User Manual 1178.3711.02 ─ 08
STEReo:DIRect "RDS-PH=<Phase>"
STEReo:DIRect? "PDS-PH"
Sets the RDS phase.
Setting parameters:
<Phase> Range: 000 to 359 (ASCII coded decimal numbers)
Example:
STEReo:DIRect "RDS-PH=100"
Sets the RDS phase.
STEReo:DIRect "RDS-DEV=<Deviation>"
STEReo:DIRect? "RDS-DEV"
(for documentation reasons only)
Sets the RDS frequency deviation (max. deviation).
Use the command [:SOURce]:STEReo:PILot[:DEViation] instead.
Setting parameters:
<Deviation> Note: Always set a four-digit value. Add leading zeros, if any.
Range: 0000 to 1000 (ASCII coded decimal numbers),
corresponding to 0 Hz to 10.00 kHz)
Example:
STEReo:DIRect "RDS-DEV=0201"
Sets the RDS frequency deviation to 2.01 kHz.
STEReo:DIRect "RDS-PRESET"
All RDS-specific parameters are deleted or set to default values.
Example:
STEReo:DIRect "RDS-PRESET"
Sets all RDS parameter to their preset values.
Usage: Event
STEReo:DIRect "RT=<RetranNumber>,<A/
BFlag>,<RadioTextMsg#1>,<RadioTextMsg#2>"
STEReo:DIRect? "RT"
Sets a flag signaling the transmission of new radio text and the message of the radio
text.
Setting parameters:
<RetranNumber> Range: 00 to 15 (ASCII coded decimal numbers), number
of retransmissions of radio text message
<A/BFlag> 0 | 1
If the A/B flag is set, the A/B bit in group 2A is toggled to signal
that a new radio text message is transmitted.
Direct commands for the stereo/rds coder option R&S SMBB-B5