Rohde & Schwarz R&S SMB100B - Page 572

Remote control commands
R&S
®
SMB100B
572User Manual 1178.3711.02 ─ 08
STEReo:DIRect "TP=<State>"
STEReo:DIRect? "TP"
(for documentation reasons only)
Sets or reads the traffic program flag. This flag signals whether traffic information is
transmitted.
Use the command [:SOURce]:STEReo:RDS:TRAFfic:PROGram[:STATe]
instead.
Setting parameters:
<State> 0 | 1
Example:
STEReo:DIRect "TP=1"
STEReo:DIRect "TRANS<DataNumber>=<DataStream>"
STEReo:DIRect? "TRANS<DataNumber>"
Transparent mode.
An RDS data stream of binary data is generated. If transparent data is selected, all
other RDS data is ignored.
Parameters:
<DataNumber> Max. 20 different data sequences can be defined.
Range: 0 to 13
<DataStream> 16 ASCII coded hexadecimal characters (blocks A to D of the
RDS groups)
TRANS=0 deletes all transparent data and switches back to nor-
mal RDS data transmission.
Note: 16 characters must be specified for each data sequence.
Leading zeros, if any, must also be specified. Transmitts the
data even if it constitutes no meaningful RDS data.
Example:
STEReo:DIRect "TRANS1=0123456789ABCDEF"
Sends the data "0123456789ABCDEF" instead of the RDS data.
Direct commands for the stereo/rds coder option R&S SMBB-B5