Rohde & Schwarz R&S SMB100B - Page 580

Troubleshooting and notifications
R&S
®
SMB100B
580User Manual 1178.3711.02 ─ 08
"Serial Number"
Serial number of the assembly.
"Revision"
Revision state of the assembly.
"Slot"
Indicates whether the assembly is connected to the serial bus or PCI
bus.
Remote command:
:DIAGnostic<hw>:BGINfo? on page 372
Counter
Displays information on the operation times of the R&S SMB100B.
Operation Time / h ← Counter
Displays the operation time in hours so far.
Remote command:
:DIAGnostic:INFO:OTIMe? on page 373
Power On Count ← Counter
Displays the number the instrument has been turned on.
Remote command:
:DIAGnostic:INFO:POCount? on page 373
Last Factory Calibration ← Counter
Displays the date of the last factory calibration.
Remote command:
:CALibration:DATA:FACTory:DATE? on page 369
13.7.2 Versions/options settings
Access:
► Select "System Config > Setup > Instrument Assembly > Versions / Options".
Requesting instrument configuration and specifications