Troubleshooting and notifications
R&S
®
SMB100B
582User Manual 1178.3711.02 ─ 08
"Version"
Current issue of the component.
E.g. the data sheet covers the technical data of the hardware compo-
nents of the factory settings.
See also Chapter 11.6.2.3, "Datasheet", on page 314.
Remote command:
:SYSTem:SPECification:VERSion:FACTory? on page 537
13.7.3 How to query instrument configuration
To get information on the components and installed options of the R&S SMB100B, pro-
ceed as described in the following examples.
Checking the installed hardware options
To find out the installed options:
1. Select "System Config > Setup > Instrument Assembly > Versions/Options".
2. Select "Hardware Options".
The dialog lists all hardware options that are installed on the R&S SMB100B.
Proceed the same way to get information for instance on the firmware, or the installed
software options in the corresponding tab.
Checking the RF hardware assembly
To find out the installed RF hardware:
1. Select "System Config > Setup > Instrument Assembly > Hardware Config".
Requesting instrument configuration and specifications
To Next Page
Loading...
