Manual Operation
R&S
®
SMBV100A
89Operating Manual 1176.8016.02 ─ 17
To access the "Graphics Settings" dialog for selecting the graphics display of the out-
put signal, select the "Graphics" function block in the diagram or press the MENU
(CTRL+M) key.
Operation of the graphics windows is analogous to menu operation.
The menu and the individual graphical displays are described in "Graphics Display" in
the Operating Manual.
4.3 Accessing Dialogs
The MENU (CTRL+M) key opens the complete menu tree. Selecting a functional block
and pressing the ENTER key opens the menu associated with this block.
An alternatively way to access a dialog is to use the Winbar buttons or front-panel soft-
keys or to use the HIDE (CTRl+H), CLOSE (ESC), DIAGRAM (CTRL+D) and REARR
(CTRL+A) keys on the front panel.
For a quick access to the dialogs, use one of the following alternative methods.
Displaying the block diagram or a dialog in the foreground
1. Press the DIAGRAM (CTRL+D) key to move the cursor to the block diagram.
All active menus are minimized and displayed in the form of Winbar buttons.
2. Press the associated softkey (CTRL+F1 .. F8) to display the dialog in the fore-
ground again.
Accessing the menu tree
► Press the MENU (CTRL+M) key to open the complete menu tree.
Calling the File, Setup or Hardcopy dialogs
► Use the FILE (CTRL+S), SETUP (CTRL+E) or HCOPY (CTRL+Y) keys to open the
respective dialog.
Minimizing an active menu
► Use the HIDE (CTRL+H) key to minimize an active menu.
It is displayed in the form of a Winbar button.
Automatically arranging displayed menus
► Press the REARR (CTRL+A) key to rearrange all open menus so that they overlap
as little as possible.
Accessing Dialogs
To Next Page
Loading...
