Instrument Function
R&S
®
SMBV100A
133Operating Manual 1176.8016.02 ─ 17
Access:
1. Select "Setup > Test > Selftest"
2. Select "Start Selftest".
The following tests are only available via remote control:
●
:TEST<hw>:DIRect on page 841
In addition, a direct test for the hardware assembly is provided only via remote control,
see :TEST<hw>:DIRect on page 841.
Start Selftest
Performs a selftest on all installed hardware options.
When completed, the R&S SMBV displays a list of all performed test cases and the
test results (passed or failed).
Note: While the self test is in progress, the actual signal level at the RF output is -50
dBm. This value is not indicated in the status bar.
Remote command:
:TEST<hw>:ALL:STARt on page 840
:TEST<hw>:ALL:RESult? on page 840
Active External IQ Device
Selects the external IQ device ("IQ IN / IQ Out").
Remote command:
n.a.
5.2.3.9 Check Front Panel
With the functions provided in this dialog you can verify the functionality of the control
keys of the R&S SMBV.
In case of malfunctions, contact your Rohde & Schwarz Customer Support Center for
technical support, see http://www.customersupport@rohde-schwarz.com.
Accessing the online help in the check front panel dialog or exiting via ESC
During the test, the actual functions of all keys are disabled, including the HELP and
the ESC keys.
General Instrument Settings
To Next Page
Loading...
