Rohde & Schwarz SMBV100A - TEST Subsystem

Remote Control Commands
R&S
®
SMBV100A
840Operating Manual 1176.8016.02 ─ 17
Usage: Setting only
7.19 TEST Subsystem
The TEST system contains the commands for performing selftest routines, and for
direct adjustment of the hardware assemblies (:TEST:DIRect).
The self tests return a "0" if the test is performed successfully, otherwise a value other
than "0" is returned. None of the commands of this system have an *RST value.
Improper use can destroy the assembly
The respective hardware assembly responds directly to the :TEST:DIRect command;
any safety mechanisms are bypassed. The command is intended for servicing purpo-
ses and should be used only by the Rohde & Schwarz service personnel.
:TEST<hw>:ALL:STARt.................................................................................................. 840
:TEST<hw>:ALL:RESult?................................................................................................840
:TEST:EIQMode............................................................................................................ 841
:TEST<hw>:DIRect........................................................................................................ 841
:TEST:BB:DATA:ERRor:RATE........................................................................................ 841
:TEST:BB:DATA:FREQuency..........................................................................................841
:TEST:BB:DATA:OFFTime..............................................................................................842
:TEST:BB:DATA:ONTime............................................................................................... 842
:TEST:BB:DATA:RDELay............................................................................................... 842
:TEST:BB:DATA:STATe................................................................................................. 842
:TEST:BB:DATA:TRIGger[:MODE]...................................................................................842
:TEST:BB:DATA:TYPE...................................................................................................843
:TEST<hw>:ALL:STARt
Starts a self-test on all installed hardware options.
To query the result, use the command :TEST<hw>:ALL:RESult? on page 840.
Example:
See :TEST<hw>:ALL:RESult? on page 840
Usage: Event
Manual operation: See "Start Selftest" on page 133
:TEST<hw>:ALL:RESult?
Queries the result of the performed self-test (command :TEST<hw>:ALL:STARt
on page 840).
TEST Subsystem