Remote Control Commands
R&S
®
SMBV100A
667Operating Manual 1176.8016.02 ─ 17
[:SOURce<hw>]:BB:DM:FILTer:TYPE <Type>
The command selects the filter type.
When a standard is selected (:BB:DM:STAN), the filter type and filter parameter are
set to the default value.
Parameters:
<Type> RCOSine | COSine | GAUSs | LGAuss | CONE | COF705 |
COEQualizer | COFequalizer | C2K3x | APCO25 | SPHase |
RECTangle | USER | PGAuss | LPASs | DIRac | ENPShape |
EWPShape | LTEFilter | LPASSEVM | APCO25Hcpm |
APCO25Lsm
*RST: GAUSs
Example:
BB:DM:FILT:TYPE COS
selects the Cosine filter type.
Manual operation: See "Filter" on page 360
[:SOURce<hw>]:DM:FILTer:PARameter
<Parameter>
Sets the filter parameter of the currently selected filter type.
To set the filter type, use command [:SOURce<hw>]:BB:DM:FILTer:TYPE
on page 667.
Parameters:
<Parameter> float
Range: 0.05 to 2.5
Increment: 0.01
*RST: 0.35
Example:
BB:DM:FILT:TYPE COS
DM:FILT:PAR 0.5
sets 0.5 roll-off factor for the cosine filter.
Modulation Settings
[:SOURce<hw>]:BB:DM:AQPSk:ANGLe...........................................................................667
[:SOURce<hw>]:BB:DM:ASK:DEPTh...............................................................................668
[:SOURce<hw>]:BB:DM:CODing..................................................................................... 668
[:SOURce<hw>]:BB:DM:FORMat.....................................................................................669
[:SOURce<hw>]:BB:DM:FSK:DEViation........................................................................... 669
[:SOURce<hw>]:BB:DM:FSK:VARiable:SYMBol<ch0>:DEViation....................................... 670
[:SOURce<hw>]:BB:DM:FSK:VARiable:TYPE...................................................................670
[:SOURce<hw>]:BB:DM:MDELay?...................................................................................670
[:SOURce<hw>]:BB:DM:AQPSk:ANGLe <Angle>
For AQPSK modulation, sets the angle alpha between the point (0,0) and the I axis.
SOURce Subsystem
To Next Page
Loading...
