Rohde & Schwarz SMBV100A - Frequency Settings; RF Frequency Dialog; Setting the RF Frequency

Instrument Function
R&S
®
SMBV100A
210Operating Manual 1176.8016.02 ─ 17
5.5.2.2 Setting the RF Frequency
To change the RF frequency, press the FREQ key and enter the desired frequency.
Changes to the RF frequency have an immediate effect (without confirmation with the
ENTER key) on the output signal.
RF Freq
Enters the RF frequency, considering the frequency offset.
Note: The SCPI command sets the level of the "Freq" display, that means an entered
frequency offset and multiplier factor are considered in the frequency value.
Remote command:
[:SOURce<hw>]:FREQuency[:CW|FIXed] on page 736
5.5.2.3 RF Frequency Dialog
The combined "RF Frequency / Phase..." dialog contains the parameters required for
configuring the frequency and settings like a frequency offset, or a multiplier factor of
an externally connected multiplier, see Chapter 5.5.2.4, "Frequency Settings",
on page 210.
Furthermore, the dialog provides additional settings parameters which are described
in:
●
Chapter 5.5.2.5, "User Variation Settings", on page 212
●
Chapter 5.5.3, "Phase", on page 212
●
Chapter 5.5.5, "Local Oscillator - LO Coupling", on page 217
5.5.2.4 Frequency Settings
RF Block