Rohde & Schwarz SMBV100A - Format Subsystem

Remote Control Commands
R&S
®
SMBV100A
554Operating Manual 1176.8016.02 ─ 17
This mode is recommended for protecting the display, especially if you operate the
instrument via remote control.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: n.a. (factory preset: 0)
Example:
DISP:PSAV ON
Activates screen saver mode.
Manual operation: See "Screen Saver Active" on page 142
:DISPlay:UPDate <Update>
Activates the refresh mode of the display.
Parameters:
<Update> 0 | 1 | OFF | ON
*RST: n.a. (factory preset: 1)
Example:
DISP:UPD ON
Activates automatic update of the display at defined time inter-
vals.
7.10 FORMat Subsystem
The FORMat subsystem contains the commands which determine the format of the
data that the R&S SMBV returns to the controller. This affects all query commands
which return a list of numerical data or block data. Reference is made to this in the
descriptions of the commands.
:FORMat:BORDer..........................................................................................................554
:FORMat[:DATA]............................................................................................................555
:FORMat:SREGister.......................................................................................................555
:FORMat:BORDer <Border>
Determines the sequence of bytes within a binary block. This only affects blocks which
use the IEEE754 format internally.
FORMat Subsystem