Instrument Function
R&S
®
SMBV100A
143Operating Manual 1176.8016.02 ─ 17
The assignment of some keys depends on the selected layout and language.
Remote command:
:KBOard:LAYout on page 562
:KBOard:LANGuage on page 561
5.2.3.15 Remote Channel Settings
The "Remote Channel Settings" dialog provides access to the settings for remote con-
trol. The dialog is opened using the SETUP or MENU key under "Remote".
► To access this dialog, press the SETUP or MENU key and select "Remote >
GPIB,...".
The "Remote Channel Settings" dialog contains the GPIB address and displays the
VISA resource strings provided for remote control via the various interfaces.
GPIB channel address
Sets the address of the GPIB channel the instrument is connected to.
Remote command:
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess on page 828
RS232 using USB adapter
Remote control via a serial interface is possible via a USB. The controller and the
instrument must be connected with the external USB/serial-adapter R&S TS1-USB
(see recommended extras in the data sheet) and a serial crossover (null modem)
cable. A USB connection requires the VISA library to be installed on the controller.
VISA will detect and configure the R&S SMBV automatically when the USB connection
is established.
In addtion, you can also use a Bluetooth connection for remote control via the serial
interface. The settings are effective for both interfaces (see also Chapter 5.2.3.18,
"Security", on page 147 ).
General Instrument Settings
To Next Page
Loading...
