Rohde & Schwarz SMBV100A - Loading Instrument Settings

Instrument Function
R&S
®
SMBV100A
162Operating Manual 1176.8016.02 ─ 17
[:SOURce<hw>]:BB:DM:DLISt:CATalog? on page 675
[:SOURce<hw>]:BB:DM:CLISt:CATalog? on page 675
Save
Saves the current instrument settings in the specified file and path.
Remote command:
:SYSTem:SAV on page 827
:MMEMory:STORe:STATe on page 575
Refer to the descriptions of the firmware options for the correct syntax of the corre-
sponding SCPI commands:
[:SOURce<hw>]:BB:<Digital Standard>:SETTing:STORe
[:SOURce<hw>]:BB:<Digital Standard>:SETTing:DELete
Fast Save
Determines whether the instrument performs an absolute or a differential storing of the
settings.
Enable this function to accelerate the saving process by saving only the settings with
values different to the default ones.
Note: This function is not affected by the "Preset" function.
Remote command:
[:SOURce<hw>]:BB:DM:SETTing:STORe:FAST on page 685
[:SOURce<hw>]:BB:ARBitrary:MCARrier:SETTing:STORe:FAST on page 632
refer to the description of frimware options for the syntax of the corresponding SCPI
commands
Save Immediate x
Saves the current instrument setting in one of the three intermediate memories.
These instrument settings are retained until a different instrument setting is saved in
the intermediate memory. When the instrument is switched off, the contents of the
intermediate memories are retained.
Remote command:
*SAV on page 508
File Manager
Accesses the "File Manager" dialog, see Chapter 5.2.8.5, "File Manager",
on page 166.
Remote command:
n.a.
5.2.8.3 Loading Instrument Settings
If "Recall" is selected under "Select Operation", the "File" menu provides options for
loading complete instrument settings. Here it is possible to select whether the current
or saved frequency and level settings are to be used.
General Instrument Settings