Rohde & Schwarz SMBV100A - Source:bb:arb Subsystem;Common Settings; Source:bb:arb Subsystem; Common Settings; [:Source<Hw>]:Bb:arbitrary:preset

Remote Control Commands
R&S
®
SMBV100A
601Operating Manual 1176.8016.02 ─ 17
7.16.3.2 SOURce:BB:ARB Subsystem
The ARB subsystem contains the commands for setting the ARB Generator. Settings
for clock and trigger interfaces and for external outputs are entered in the
SOURce:INPut and SOURce:OUTput subsystems.
Section Chapter 7.4, "Waveform and List Format", on page 511 describes the ARB
waveform format and how it is used to transmit waveforms via the IEC bus.
● Common Settings..................................................................................................601
● Clock Settings....................................................................................................... 602
● Trigger Settings.....................................................................................................604
● Marker Settings.....................................................................................................611
● Test Signals Settings............................................................................................ 615
● SOURce:BB:ARB:MCAR Subsystem................................................................... 618
● SOURce:BB:ARB:WAV Subsystem......................................................................633
● SOURce:BB:ARB:WSEG Subsystem...................................................................637
Common Settings
[:SOURce<hw>]:BB:ARBitrary:PRESet............................................................................ 601
[:SOURce<hw>]:BB:ARBitrary:STATe..............................................................................601
[:SOURce<hw>]:BB:ARBitrary:PRESet
Sets all ARB generator parameters to their default values.
Example:
SOURce1:BB:ARB:PRESet
Usage: Event
Manual operation: See "Set To Default" on page 386
[:SOURce<hw>]:BB:ARBitrary:STATe <State>
Activates the standard and deactivates all the other digital standards and digital modu-
lation modes in the same path.
You have to selecta an waveform first.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce1:BB:ARBitrary:WAV:SELect 'wave1'
loads waveform file from the default directory.
SOURce1:BB:ARBitrary:TRIGger:SEQ RETR
sets trigger mode Retrigger.
SOURce1:BB:ARBitrary:STATe ON
switches on the ARB generator. The selected waveform is out-
put straight away. A trigger event causes restart.
Manual operation: See "State (ARB)" on page 385
SOURce Subsystem